ADY 3D Model Configuration
This tool does not apply engineering rules to model code combinations. Engineering rules will be applied at time of order. Sequences that do not affect the external appearance of the model may not be displayed.
- Sequence 1 code title PRESSURE COMPENSATED/PRESSURE FLOW COMPENSATED OPEN CIRCUIT PISTON PUMP ADY 1
- Sequence 2 displacement 74.0 CM3/R [4.51 IN3/R] 2
- Sequence 3 input shaft rotation LEFT-HAND ROTATION (CCW) LEFT SIDE SUCTION PORT, RIGHT SIDE PRESSURE PORT 3
- Sequence 4 front mounting & input shaft 4 BOLT C (SAE J744-127-4) WITH 14 TOOTH 12/24 PITCH SPLINE SHAFT (SAE J744-32-4) 4
- Sequence 5 main ports size & location 74 SIDE PORTS; SUCTION - 2.00 SAE J518 4-BOLT SPLIT FLANGE PORT STANDARD PRESSURE SERIES (CODE 61); PRESSURE - 1.00 SAE J518 4-BOLT SPLIT FLANGE PORT STANDARD PRESSURE SERIES (CODE 61) 5
- Sequence 6 drain port size & location 1.3125-12 UNF-2B O-RING PORT - TOP 6
- Sequence 7 diagnostic pressure ports NO DIAGNOSTIC PRESSURE PORTS 7
- Sequence 8 controller type PRESSURE AND FLOW COMPENSATOR WITH .4375-20 SAE O-RING LOAD SENSE PORT LEFT SIDE 8
- Sequence 9 pressure compensator setting 275,8-282,7 BAR [4000-4100 LBF/IN2] 9
- Sequence 10 flow compensator setting 19-21 BAR [276-305 LBF/IN2] 10
- Sequence 11 torque control setting NO TORQUE CONTROL 00 11
- Sequence 12 control special features BLEED DOWN ORIFICE 12
- Sequence 13 maximum displacement option EXTERNAL MANUAL STROKE ADJUSTMENT (SET AT MAXIMUM) 13
- Sequence 14 auxiliary (rear) mount & output shaft No Preference 14
- Sequence 15 shaft seal STANDARD FLUOROCARBON SHAFT SEAL 15
- Sequence 16 pump special features NO PUMP SPECIAL FEATURES 16
- Sequence 17 paint BLUE PRIMER 17
- Sequence 18 identification / packaging MARK DANFOSS PRODUCT NUMBER AND FULL MODEL CODE ON LABEL 00 18
- Sequence 19 design code SECOND DESIGN B 19
- Blank Blank Blank
View and Download
Make sequence selections in order of most important to least to find a single 3D model. Only visually distinguishable features are available for configuration, features not relevant to 3D modeling have been omitted.
No models are available for your selections. Select the no preference option on sequences starting with least important until a model becomes available.