22 3D Model Configuration
This tool does not apply engineering rules to model code combinations. Engineering rules will be applied at time of order. Sequences that do not affect the external appearance of the model may not be displayed.
- Sequence 1 product MOTOR M 1
- Sequence 2 series 2000 SERIES (2-SPEED 1:2 RATIO) 22 2
- Sequence 3 displacement 244.3 CM3/R [14.94 IN3/R] 3
- Sequence 4 mounting type STANDARD, 2 BOLT, 101.6 [4.00] PILOT DIA. 14.35 [.565] DIA. HOLES ON 146.0 [5.75] DIA. BOLT CIRCLE (SAE B) 4
- Sequence 5 output shaft 31.75 [1.250] DIA. FLAT ROOT SIDE FIT, 14 TOOTH, 12/24 DP 30 DEG. INVOLUTE SPLINE WITH .375-16 UNC-2B THREAD IN END, 33.0 [1.30] MINIMUM FULL SPLINE LENGTH 5
- Sequence 6 port type .875-14 UNF-2B SAE O-RING PORTS - STAGGERED PORTS WITH ADDITIONAL MOUNTING HOLES WITH .375-24 UNF-2B THREAD 6
- Sequence 7 case flow option/selector valve .5625-18 UNF-2B SAE O-RING CASE DRAIN PORT, .4375-20 UNF-2B SAE O-RING PILOT CONTROL PORT, OPTIONAL .4375-20 UNF-2B SAE CASE DRAIN PORT FOR PILOT OPERATED NORMALLY LOW SPEED 7
- Sequence 9 pressure flow option NONE 00 9
- Sequence 11 seal option STANDARD 0 11
- Blank Blank Blank
View and Download
Make sequence selections in order of most important to least to find a single 3D model. Only visually distinguishable features are available for configuration, features not relevant to 3D modeling have been omitted.
No models are available for your selections. Select the no preference option on sequences starting with least important until a model becomes available.